Initialising the device
99
Connected passive readers:
If several readers are connected, these are recognised in turn by the Access
Manager. All LEDs light up in the following sequence for initialisation on a
reader which has already been recognised:
one long yellow flash
one short red flash
one short green flash
one short yellow flash
one short blue flash
one long yellow flash
After this, the device goes through all possible colours once. This can take up
to 10 seconds and after this the device restarts.
This process repeats itself once for each reader. The LEDs flash alternately in
red and violet following the signal sequence until all connected readers have
been recognised. The upper LEDs permanently light up red on all connected
readers once all readers have been recognised.
Connected ENiQ Module Reader:
The status LED of the reader goes out and the control LED permanently lights
up red. No flashing sequence is issued.
The devices are initialised and put into operation.
DOM Tapkey Access Manager Compact & HiSec:
The DOM Tapkey devices can only be put into operation by using the Tapkey
app.
Follow the instructions in the Tapkey app for initialisation.