The audio signal for the
particular music channel was
temporarily interrupted by a
technical problem.
Poor satellite signal quality
sometimes due to sunspots or
inclement weather.
The DR500
was subjected to
excessive vibration or
movement.
Wait for the music to begin again. If this
is a frequently re-occuring problem,
contact your DMX MUSIC affiliate.
Ensure that the DR500 is in an
appropriate location away from vibration
or movement that may cause the music
to stop momentarily
Problem
Possible Causes
Solutions
No sound
The stereo is turned off or
the volume is turned down.
The DR500 Receiver
volume is turned down.
The Mute function is
selected.
You are not authorized to
receive the current channel.
The DR500 and stereo
connectors are not correctly
attached.
Turn on the stereo and
adjust the volume.
Turn the volume up on the
DR500 Receiver.
To return to normal volume,
press MUTE on your
remote control.
Tune to an authorized
channel (refer to Section 3).
Contact your DMX MUSIC
affiliate if you wish to
receive the music channel.
Check all DR500 and
stereo connections.
No sound from one speaker Balance is incorrectly set or
your stereo/speaker
connections are not
correctly adjusted.
Adjust the balance controls
on stereo and check all
connectors.
Remote control does not
operate the DR500.
The remote control is not
pointed at the DR500;
The remote control is too
far from the DR500;
The path between the
DR500 and remote control
is obstructed.
The DMX MUSIC/DJ mode
is not set to the correct
mode.
Front panel lockout is set
Point the remote control
directly at the DR500.
Ensure that there are no
obstacles between the
DR500 and the remote
control unit.
Move to within 10 meters of
the DR500.
Remove the obstruction,