If the Audio Equipment Has a Direct Digital Coaxial Input
To connect the DR500 to audio equipment with direct digital input, refer
to the figure below and the following instructions.
Connect a shielded RCA cable (not provided) from the DIGITAL OUT
connector on the DR500 to the coaxial DIGITAL INPUT connector on the
audio equipment. (See your stereo manual for specific requirements.)
The default output format is uncompressed PCM; it may optionally be
configured as Dolby Digital. Contact your DMX MUSIC Affiliate to
reconfigure the S/PDIF output as Dolby Digital.
Antenna Installation and Alignment
It is recommended that the Satellite dish antenna be installed by your
local DMX MUSIC Affiliate. It is imperative that the dish be securely and
safely mounted, and pointed accurately at the Satellite. Brief instructions
are presented here for completeness.
Satellite Dish Installer:
Ground the RF input cable to the building
grounding system as close as possible to the point of building entry.
Refer to the National Electric Code (NEC) Article 820-40.
The following steps describe the process to properly set up, position, and
connect the antenna using the DR500 Receiver:
1. Determine the proper block converter and feed horn polarity
adjustment for your area.
2. Assemble the satellite dish antenna.
3. Locate the antenna in an area with an unobstructed line of sight to
the satellite coordinates (azimuth and elevation) for your area.
For information relating to satellite location and coordinates,
antenna alignment, and signal acquisition, contact your DMX
MUSIC affiliate.
