Dish Network Dish 322, User Manual

Page: 80 / 128

Chapter 3
Page 76
Using the System
Setting SAT Auto-Tune Channel
1. Make sure the remote control operates your TV.
2. Press and hold the TV mode button until all four mode buttons are lit.
3. Press STAR ( * ), then enter the channel used for viewing satellite TV.
You can enter up to three digits in the range of 002 to 125. For example,
if the TV needs to be on channel 100, enter *100.
4. Press POUND ( # ). The TV mode button flashes three times to indicate
programming was successful.
Disabling the SAT Auto-Tune Channel
If you decide that you do not want the TV programmed to the TV channel
used for viewing your paid programming, follow the steps below to disable
SAT Auto-Tune. This only needs to be done if you followed the steps for
Setting SAT Auto-Tune Channel on page 76.
1. Press and hold the SAT mode button until all four mode buttons are lit.
2. Press the STAR ( * ) button, then press VOLUME DOWN .
3. Press the POUND ( # ) button. The SAT button flashes three times to
indicate SAT Auto-Tune was disabled.
Enabling SAT Auto-Tune
Note : SAT Auto-tune is enabled by default; however, after enabling SAT
Auto-Tune, the channel must be set (see Setting SAT Auto-Tune Channel ). If
you disable the SAT Auto-Tune Channel and decide that you want to use this
feature, you must enable the feature and then set the channel.
1. Press and hold the SAT mode button until all four mode buttons are lit.
2. Press STAR ( * ), and then press VOLUME UP .
3. Press POUND ( # ). The SAT mode button flashes three times to indicate
SAT Auto-Tune was enabled.
Removing SAT Auto-Tune Channel
1. Press and hold the TV mode button until all four mode buttons are lit.
2. Press STAR ( *) , and then enter 00 or 000 .
3. Press POUND ( # ). The TV mode button flashes three times to indicate
programming was removed.