Dish Network Dish 322, User Manual

Page: 30 / 128

Chapter 2
Page 26
Receiver Description and Installation
Removing the Recover Button Channel Programming
The following instructions describe how to reset the RECOVER button to
the way it was delivered to you from the factory.
1. Press and hold the
TV mode button until all the other mode
buttons light up, and then let go of the button. The TV mode
button flashes.
2. Press the STAR ( * ) button.
3. Press 0-0-0 .
4. Press the POUND ( # ) button. The TV mode button flashes
three times.
Changing the TV1 and TV2 Output Channels
The receiver comes preset to use channel 3 for
TV1
and off-air channel 60
for
TV2
. If you are experiencing interference on the channels you are using,
follow these instructions to change the channel that
TV1
or
TV2
uses.
1. Press MENU-6-1-5 to open the
Modulator Setup
screen.
2. For
TV1 Out
, highlight the number under
TV1 Out
. For
TV2 Out
skip to
step 4.
3. Use the UP and DOWN ARROW buttons to change the modulator
channel either
3
or
4
. Continue to the next step to set
TV2 Out
or skip to
step 7 if you are finished making changes.
4. For
TV2 Out
, select either
Air
(for off-air channel numbers) or
Cable
(for cable channel numbers).
Make sure you are familiar with how to change channels on
your TV and if necessary how to switch your TV between off-
air and cable channels. When you change these receiver output
channels, you must also change the channels on your TV(s) to
tune to these channels to see the video from the receiver. See
your TV user guide for instructions.
Tip: It’s easier to
set the output
channel from the
opposite TV. For
example, if you are
changing the out-
put on TV1 (nearby
TV), use TV2
(remote TV) to
make the change.
When you save the
changes, simply
remember to
change the chan-
nel on the nearby
TV.