Dish Network Dish 322, User Manual

Page: 33 / 128

Page 29
Connecting the Receiver to a Dish Antenna System
2. Peel off the blue stickers and affix them to the cables close to where
they connect to the
S
ATELLITE
I
N
1
and
S
ATELLITE
I
N
2
connections on
the back of the receiver.
3. On Remote Control 1, press the MENU-6-1-1 to display the
Point
Dish/Signal
screen on the nearby TV.
4. Select
Check Switch
. When an attention screen displays, select
Test
.
5. The receiver begins performing the
Check Switch
tests. When it is
finished, the
Installation Summary
screen displays.
Note : Your
Installation Summary
screen may differ from the one
displayed below.
6. Make sure that the information on the
Installation Summary
screen
identifies your system correctly and shows all transponders for all
satellites in your system. Your screen may look different from the
example above depending on the dish antenna system you are using.
7. Select
OK
to go to the
Point Dish/Signal
screen.
8. Select
Cancel
to exit the
Point Dish
menu. An
Attention
screen will
open asking if the mounting and positioning of your dish is complete
with a
Locked
indication in the
Point Dish
screen. If the answer is yes,
select
Yes
.
If the answer is
No
, you need to repoint your dish following the
preceding steps until the mounting and positioning is complete, and you
have the
Locked
indication.
9. After you select Yes , the receiver begins taking a software upgrade. A
Warning
appears stating that
Vital program information will now be
downloaded into your receiver
. A status bar showing the progress of
this upgrade also appears.
Tip: Using cable
labels makes it
easy to tell which
cables connect to
the receiver ports.
Inside the front
cover of this guide
are stickers that
are color-coded
the same way as
the coaxial
connections.