Dish Network Dish 322, User Manual

Page: 25 / 128

Page 21
Connecting the Receiver to the TV(s) in Another Room(s)
Connecting the Receiver to the TV(s) in Another
Room(s)
This section describes how to connect the receiver
CH 21–69 O
UT
connection to the cable-ready remote TV located in another room away
from the receiver. This installation uses your in-home cable system. If your
house does not have built-in cabling, it will be necessary to run cables from
the receiver to each remote TV. Due to the difficulty of this installation, you
should consider having this professionally installed. Call DISH at 1-800-
333-DISH (3474).
Note
: When connecting to the home distribution (
CH 21–69 O
UT
) coaxial
port, you must meet the FCC requirements in the Appendix (see page 117).
To meet these requirements, an in-line coaxial attenuator has been included
with your receiver and may need to be installed using the following
guidance:
• If connecting to your in-home cabling system to distribute the signal to
a TV(s) in other rooms, in most cases you will not have to install the
attenuator on the
CH 21–69
port for typical in-home cabling systems.
• If connecting directly to a TV tuner port, you must install the attenuator
in the cable between the
CH 21–69 O
UT
port and the TV tuner.
If you have an off-air antenna or cable connected to your in-
home cable system, see Optional—Connecting to an Off-
Air Antenna or Cable following this section (see page 31).
Channel 21-69 Out
Remote TV
Existing Wall
Cable System
Outlet
Four-way
Splitter
Remote TV
UHF
Remote
UHF UHF
PRO
Attenuator
Receiver Back Panel
To Remote TV