Dish Network Dish 322, User Manual

Page: 32 / 128

Chapter 2
Page 28
Receiver Description and Installation
2. Select the
Touch Tone
or the
Rotary/Pulse
option in the
Phone Type
list.
3. Select either the
No Prefix
or the
Prefix Code
option in the
Outside
Line Prefix
list.
Note
: Usually, you need a telephone number prefix only for business
installations. For most residential installations, all you need to do is set
the telephone system type. The default setting of
No Prefix
will allow
correct dialing.
4. If you selected the
No Prefix
option, select
Save
to finish.
5. If you selected the
Prefix Code
option, the receiver highlights the box
(highlighting the top box) where you must enter the digits. To do this, do
the following:
a. Enter the number of digits required to obtain an outside line in the
top box.
b. Move the highlight to the bottom box.
c. Enter the exact sequence you dial the phone to obtain an outside line
in the bottom box.
d. Select the
Save
option to save the settings.
Connecting the Receiver to a Dish Antenna System
Note : Before you can begin connecting your receiver to your dish antenna,
you must first complete the preceding sections on connecting your TVs to
the receiver. Once you have a dish antenna system installed and peaked for
maximum signal strength, complete the following instructions to connect the
dish antenna system to the receiver.
1. Connect the cables to the
S
ATELLITE
I
N
1
and
S
ATELLITE
I
N
2
ports on the
receiver’s back panel as illustrated in the Satellite Connections diagrams
above.