Page 41
Using the Remote Controls
Recover Button
Press the
RECOVER
button if you accidentally change the channel or
video input on your TV and cannot get the picture back from your satellite
receiver. When you press the
RECOVER
button as described below, the
remote control sends commands to your TV to change channels or video
inputs to try to get you back to watching satellite programming. This
procedure works only if you have accidentally changed the TV channel or
video input. It does not recover lost satellite signal (see
Chapter 4—Reference
for troubleshooting information).
The
following setup is required to use the
RECOVER
button:
•
The remote control must be set up to control the TV and, if installed, the
VCR (see page 75).
•
If a VCR is installed, make sure it is connected as shown on page 30.
•
On a remote TV, the
RECOVER
button must be programmed to tune
your remote TV to the specific channel to receive TV2 programming
(for example, channel 60), using the instructions on page 25.
To use the
RECOVER
button, complete the following instructions:
1. Press and hold the
RECOVER
button until all four mode buttons light,
and then let go of the button. The
SAT
mode button flashes twice and
then all four mode buttons flash three times.
2. Press the
RECOVER
button. Wait for the TV or
VCR
mode button to
flash once and then all four mode buttons to flash once.
3. If you see the
System Info
screen, press the
SELECT
button to close
the screen. You have recovered your satellite video.
4. If you do not see the
System Info
screen, repeat steps 2 and 3 until you
have recovered your satellite video.
Note
: Press any remote control button other than the
RECOVER
button to end this procedure.
Note
: If the
RECOVER
button is not programmed to a specific
channel, the
RECOVER
button will first try to tune your TV to channel
3, then channel 4, and then other video inputs with each press of the
RECOVER
button. You may need to press the
RECOVER
button up
to 30 times to recover your satellite TV video. If the
RECOVER
button
is programmed to a specific channel (see page 25), the
RECOVER
button will tune the TV to the specific channel (for example,
channel 60).
Summary of Contents for Dish 322
Page 40: ...Chapter 2 Page 36 Receiver Description and Installation Notes...
Page 104: ...Chapter 4 Page 100 Reference Notes...
Page 127: ...Page 123 Index NOTES...
Page 128: ...Index Page 124 NOTES...
