Dish Network Dish 322, User Manual

Page: 31 / 128

Page 27
Connecting the Receiver to the Phone Line
5. Highlight the number under
TV2 Out
.
6. Use the UP and DOWN ARROW buttons to change the modulator
channel to one of the following:
•
Air Mode
—Select a channel between
21
and
69
.
•
Cable Mode
—Select a channel between
73
and
125
.
7. Select
Done
to save the changes.
8. Change the channel on your TV(s) to match the channel(s) you selected.
9. To remind you which TV channel was tuned to get satellite
programming, place a channel sticker near or on your TV to indicate the
correct channel.
10. If you changed your
TV2 Out
channel, repeat Programming the
Recover Button (see page 25).
Connecting the Receiver to the Phone Line
Keep the receiver connected to an active telephone line so you can order
pay-per-view programs and use all of the DISH Interactive features.
Note
: You may be able to use a wireless telephone extender. However, this
may not support all the features of this receiver, such as Caller ID.
Note
: If you have a Digital Subscriber Line (DSL), you may have to install
a DSL filter between the receiver’s back panel
P
HONE
J
ACK
and the
telephone wall jack to successfully connect with the DISH. You can obtain a
filter from your DSL provider.
Phone Line Connection
Run a telephone cable with a standard RJ-11 connector from the receiver’s
back panel
P
HONE
J
ACK
to an active telephone connection.
Phone System Setup
You must also set up the receiver for your telephone system (touchtone or
rotary/pulse), and set a telephone number prefix, if you need a prefix to
make an outside call.
1. Display the
Phone System
screen by pressing MENU-6-1-4 .
Tip: The channel
stickers are located
inside the front
cover of this guide.