Dish Network Dish 322, User Manual

Page: 38 / 128

Chapter 2
Page 34
Receiver Description and Installation
Setting Up TV1 to Operate in UHF Pro
You can set your receiver to operate your TV1 using another UHF Pro
remote control (sold separately) by completing the following instructions:
1. Perform the following using an existing remote control:
a. Open the
TV1 UHF Pro Setup
screen by pressing MENU-6-1-8 on
the remote control.
b. Select
Enable
from the
TV1 UHF Pro Setup
screen.
c. Select
System Info
to open the
System Info
screen.
d. Move the highlight to the address for the
Primary Remote Address
as shown below. This is important—if you do not do this, your
remote will change the receiver's
Secondary Remote Address
and
cause your Remote Control 1 to control the side of your receiver.
2. Perform the following using the UHF Pro remote that you are going to
use to control TV1:
a. Press and hold the
SAT
mode button about three seconds, until all
the mode buttons light up, and then let go of the
SAT
button. The
SAT
mode button will blink.
b. Use the
NUMBER PAD
buttons to enter any number from
1
to
16
,
except for the number shown by the
Secondary Remote Address
.
The
SAT
mode button goes out after you enter each digit, and then
lights up again.
Write down the number you entered:
c. Press the
POUND
(
#
) button. If you entered the address correctly,
the
SAT
mode button will flash three times.
d. Press the
RECORD
button.
e. Make sure the
System Info
screen shows that the
Primary Remote
Address
shows
UHF Pro and IR
and that this address matches
the number you entered in step b.
If you set up your DISH 322 to operate the side using UHF Pro,
the two UHF Pro remotes for this receiver will interfere with
each other when operated at the same time. This may prevent
the remotes from operating the receiver momentarily.
Primary Remote Address 1 IR
Note : Highlight the
Primary Remote
Address
.