Dish Network Dish 322, User Manual

Page: 19 / 128

Page 15
Receiver Back Panel
S-Video Out
The
S-V
IDEO
connection provides the highest quality video
available to your nearby TV (if your TV has this connection).
Use an S-Video cable to make the connection. If you use this
back panel output for video between your receiver and
nearby TV, you must still connect the audio using the
P
HONO
(RCA) A
UDIO
L
EFT
/R
IGHT
O
UTPUTS
and Phono (RCA) cables.
TV Antenna/Cable In
The
TV A
NTENNA
/C
ABLE
I
N
is used if you want the satellite
receiver to connect the tuner of the nearby TV to an off-air
antenna or cable TV system when the satellite receiver is
turned off or when using the TV/VIDEO button on Remote
Control 1. Use a coaxial cable to make this connection to an
off-air antenna or cable TV system. The
TV A
NTENNA
/
C
ABLE
I
N
connection is color-coded black. Your nearby TV
must be connected to the
C
HANNEL
3-4
output to use this
feature.
TV2 Connections
The following connections provide TV2 menus and programming to the
remote TVs.
Ch 21–69 OUT
The
C
H
21–69 OUT
connection provides good quality video
and mono (non-stereo) audio for the remote TV(s).
Use a coaxial cable to make this connection to your home
cable system. Remote TVs connected to the home cable
system can receive programming from this receiver output.
The
C
H
21–69 OUT
connection is color-coded yellow.
• If connecting directly to a TV tuner port, you must install the
attenuator in the cable between the
C
H
21–69 O
UT
port and the
TV tuner.
• If connecting to your in-home cabling system to distribute the
signal to a TV(s) in other rooms, in most cases you will not
have to install the attenuator for most in-home cabling systems.
When connecting to the home distribution (
C
H
21–69 OUT
)
coaxial port, you must meet requirements covered under FCC
Compliance in the Appendix (see page 117). To meet these
requirements, an in-line coaxial attenuator has been included and
may need to be installed using the following guidance:
Tip: If you connect
a cable to the TV
A
NTENNA
/C
ABLE
I
N
port, attach the
black sticker to the
cable near where it
attaches to the
receiver. The
stickers are
located inside the
front cover of this
guide.