Dionex UltiMate FLM-3100, Operating Instructions Manual

Page: 44 / 101

UltiMate 3000 Series: Flow Managers and Column Thermostats
Page 38 Operating Instructions
1. Use the special capillary that is shipped with the Application Kit to connect the flow
manager to the pump (
→
Fig. 11, page 19).
Description Part No.
Long capillary for connecting the pump to the flow splitter
(including the appropriate fittings and ferrules)
Standard version
Biocompatible version
Use this capillary, for example, when the system modules are stacked
as shown in Fig. 14 (
→
page 26).
6035.2550
6037.2550
Short capillary for connecting the pump to the flow splitter
(including the appropriate fittings and ferrules)
Standard version
Biocompatible version
Use this capillary, for example, when the pump is directly on the flow manager.
6035.2553
6037.2553
Important: Do not substitute the capillaries mentioned in the above table for
any other capillary.
♦
Connect the capillary to the pump. Bend the capillary for connection to the
flow splitter if necessary.
♦
Rinse the capillary with isopropanol, via the pump (maximum flow rate, 5
minutes).
♦
Connect the capillary to the flow splitter (
→
pump connector, Fig. 11, no. 6).
Tip: The pump outlet connector and flow splitter are equipped with a filter frit
to catch any particles that might have entered the capillary during
installation. Usually, it is not necessary to change these frits.
2. Establish the connection to the capillary connector (
→
Fig. 11, no. 4) as required by
your application. For the system structure shown in Fig. 14, connect the capillary to
the flow manager's right switching valve (port 4;
→
page 35).