Dino lift DINO 180 T, Operation Instructions Manual, Page: 77 / 92

DINO 180T-1
77
PROPO -CONTROL CARD
(48.2127)
1. MAXIMUM MOVEMENT SPEED
2. MINIMUM START-UP
3. FUNCTIONAL DELAY (0)
4. FREQUENCY
Propo-control card is adjusted before regulating potentiometers TR1, TR2 and TR3 (Exist on the
mainboard 48.2197).
(Propo -control card has been adjusted at the factory.)
Instructions for the setting of the propo card IN FOLLOWING ORDER:
2. Minimum start-up
- connect the pressure gauge to the pressure measuring point
- turn the potentiometer fully to the counter-clockwise
- turn the potentiometer clockwise until the hydraulic pressure starts to increase; after this back to
counter-clockwise about 30°
1. Maximum movement speed
- turn the potentiometer fully to the clockwise
- operate the boom upwards from the upper control panel and turn the potentiometer to the counter-
clockwise so that the movement starts to slow down
- the movement speed of the lifting is adjusted (the length of the boom is in the minimum) to 2 m (6'7")
in 14 sec., when the measurement is made from the platform.
Caution! The movement speed of the lifting function must always be adjusted lower than the max.
speed of hydraulic pump
3.Functional delay
- the potentiometer is adjusted to fully counter clockwise (delay 0)
4. Frequency
- the potentiometer is adjusted to fully counter clockwise, then back to clockwise about 180°
1 2 4 3