Dino lift DINO 180 T, Operation Instructions Manual, Page: 18 / 92

DINO 180T-1
18
STARTING UP THE LIFT
1. Ground stability
- Make sure that the ground is even and level, and hard enough to support
the lift in a steady, level position (see table below).
- On soft ground, support plates that are large and stable enough should be placed
under the support outriggers (see figure below).
- Always make sure that the support feet cannot slip because of ice, rain or ground inclination.
- It is prohibited to use the lift, if it is not properly supported and completely level.
2. The lift should be driven or pushed onto the area where it is to be used.
- Apply the parking brake
- Disconnect the towing vehicle
Ground material Density Max. ground
pressure
P kg/cm²
Gravel High density 6
Medium density 4
Loose 2
Sand High density 5
Medium density 3
Loose 1,5
Fine sand High density 4
Medium density 2
Loose 1
Sand/ mud High density (very hard to work) 1,00
Medium density (hard to work) 0,50
Loose (easily worked) 0,25