Dino lift DINO 180 T, Operation Instructions Manual, Page: 63 / 92

DINO 180T-1
63
TEST LOADING IN CONJUNCTION WITH THE REGULAR SERVICE
1. Place the lift on an even surface with good carrying capacity, and lift it up with the supporting
outriggers. Lift it as high as possible with the support outriggers
(the support area is as small as possible)
2. Turn the boom off the towbar and lower it.
3. Load the platform with 215 kg (474 lbs)
Case I
4. Turn the boom as high as possible and extend the telescope as far as possible
(max. elevation)
5. Lower the boom until the safety device stops the movement.
6. Turn the boom more than a full circle
7. Retract the telescope and lower the boom to horizontal direction.
8. Extend the telescope until the limit switch RK4 stops the movement. Establish the standing stability
at this extension length by turning the boom more than 360°
9. Go through the same procedure with a platform load of 80 kg (177 lbs)
Case II
10. Compare the sideways reach with the data in the reach diagram. If necessary, adjust as described on
page 52 "Setting the overload switches"
When the abovementioned test loadings (case I and case II) as well as the subsequent inspection have
been made without any defects in the structure or stability of the lift being found, the lift may be used on
the condition that the reach and platform load restrictions (see p. 6) are observed.
The max. allowed platform load is 215 kg (474 lbs).
- In the first inspection a test loading is made with an overload of 25 % after which the supporting
structures are carefully inspected.
- In conjunction with the annual inspections, a test run with the highest allowed load should be made,
after which the supporting structures must be carefully inspected.
- The data from the first inspection are recorded in the inspection protocol. The test runs should be
recorded in the annual inspection protocols and in the regular inspection protocol.