Dino lift DINO 180 T, Operation Instructions Manual, Page: 19 / 92

DINO 180T-1
19
3. Power connection
A. AC power
- Connect the mains cable (230VAC or 110VAC)
- Turn on the mains switch
- Voltage should be
•
230VAC (-10%/ +6%), frequency 50Hz, and mains fuse 16A
•
110V ± 15V, frequency 50Hz, and mains fuse 16A (GB)
•
110V ± 15V, frequency 60Hz, and mains fuse 16A (US)
when electric motor is loaded with max. load
(using a long cable may cause a voltage drop)
B. Interna combustion engine power (petrol/ gasoline aggregate)
- Do not connect the mains cable (230 VAC or 110 VAC)
- Turn on the mains switch
- Open the fuel cock
- Turn on the choke
Starting the engine when the battery is flat:
Press the push button located in the bed of the aggregate and pull the starter grip at the same time.
Pull the starter grip lightly until you feel resistance, then pull briskly.
Caution! Do not allow the starter grip to snap back against the engine. Return it gently to
prevent damage to the starter.
- Adjust the motor running speed to middle position
Keep the aggregate running between movements too, because the battery will only be charged when the
aggregate is running.
Attention! The fuel cock must be closed when the lift is towed!
4. Open the chassis control panel cover
Check that the battery voltage is adequate to make sure that the emergency descent system is in working
condition.
The charging level of the battery is indicated by two LEDs.
When charging the battery the red LED is on and the green one is off.
-
when the battery is charged to 80% , both LEDs are on
- when the battery is fully charged, the green LED is on and the red one blinks
- if both LEDs are on after full charging, the battery is dead.
5. Turn the operating switch (1) into position 1
6. Start the motor with pushbutton 2 (green)
Petrol/ gasoline engine
- switch off the choke
- adjust the motor running speed