Dino lift DINO 180 T, Operation Instructions Manual, Page: 26 / 92

DINO 180T-1
26
EMERGENCY DESCENT SYSTEM
As a precaution for a possible power failure, the lift is equipped with a battery operated emergency
descent system.
1. Emergency descent system
- Battery, 12V 26Ah
- Charger
- 12 VDC hydraulic unit
2. Servicing the battery
- The system is equipped with an automatical, thermal and short circuit protected charging
system
- rated power 72VA
- function voltage 0…14,4V
- charging 6A
- If necessary, fill up water so that the cells are covered
3. The hydraulic unit is made up of the following parts:
- pressure limiting valve, pressure setting 16 MPa (160 bar)
- hold valve
- 700W DC motor
The emergency descent system is started from the pushbutton 20 on the platform or 5 on the chassis
control panel. The system is activated only when the button is pressed.
Note!
When using the emergency descent system, always first retract the telescope and then lower and turn (if
necessary) the boom.
The system can also be used to lift up the outriggers.
If the emergency descent system does not work, try to get the attention of other persons on the site.
They should try and supply the power needed for normal operation, or alternatively try and get the
emergency descent system working e.g. by changing to a well-charged battery.
Always make sure that the battery of the emergency descent system is in good condition before using
the lift (see page 19).