Dino lift DINO 180 T, Operation Instructions Manual, Page: 23 / 92

DINO 180T-1
23
12A. Measures to be taken after overload situation.
(Overload limit switch RK5 disconnects the electric circuit from the controls and the platform
alarm horn on.)
- retract the telescope by pressing ”telescope in” -pushbutton (30 or 31) until the platform reaches
the permissible reach zone (the green light in the upper control panel is lit)
- after this the lift can be used normally
Telescope in –pushbutton (30 tai 31) always works when the electric motor is running or when
pressing the emergency descent start –pushbutton (5 tai 20).
Warning!
When the red overload warning light (18) is lit, no additional weight may be placed on the platform (e.g.
a second person, tools or the like)
Example: A single person on the platform extends the telescope, or alternatively somebody operating
the chassis control panel extends it as far as it will go low above the ground. When the overload warning
light lits no load may be added to the platform. The telescope should be retracted.
If the emergency descent system or other safety devices are not functioning properly, they must be
repaired before using the unit.
13. Check the daily inspections list in the operators manual and make all the inspections
mentioned therein.
14. With the boom slightly raised and the telescope slightly extended, check that the platform does
not lower itself when no operating controls are used.
15. In cold environments, the engine should be run for a short time to raise the oil temperature.
Start operating the unit carefully making the movements slowly back and forth without platform
load from the lower control panel.
16. Move the work platform to the working area.
The platform can be driven with continually adjustable speed from the platform controls (not from the
lower control panel). It is not possible to make more than one movement at a time. If more than one of
the operating levers is used simultaneously, the movement demanding the least effort (power) will be
executed.
Note!
When lowering the platform into transport position always retract the telescope fully first and place the
platform at right angle to the boom, before lowering onto the transport supports.
Take care not to damage the jockey wheel!
When working do not take additional load onto the platform!