78
5. Press the
MU
key, the display will show the following:
the
MU
mode indicator on the display is lit. The loco address in the
L
side
of the display will blink to show that it is the address that will be consisted
to the address on the
R
Throttle
.
6. The DT402 display will prompt you to press the
Y / +
key to add the loco
address or the
N / -
key to remove the loco address from the consist con-
trolled by the TOP loco address selected on the
R
Throttle
. You will see
the display alternate between the following two screens to remind you of
which key to press.
7. Press the
Y / +
key to add the left address to the consist.
The
L
Throttle
display shows the address of the loco that was added to the
consist with a
cn
in the text line above it. The
R
Throttle
display shows the
address of the TOP loco address and its current % of full speed. The
R
Throttle
is now in control of the speed and direction of both locomotives
in the consist.
8. Once a consist is set up and linked to the TOP locomotive, this TOP loco
can be released and selected to run from either throttle on your DT402.
The consist can also be dispatched to another throttle.
You can access the functions of any loco in the consist by selecting the consist-
ed loco to a throttle and using the function keystrokes outlined in
Section 13.0.
You will not be able to change the speed or direction of any loco that is part of
a consist but is not the TOP loco, while it is consisted.