114
FCC Information
Radio or TV Interference: (this information is MANDATED by the FCC) This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measure
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different form
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note that any modifications to the equipment not expressly approved by
Digitrax voids the user’s authority to operate under and be in compliance with
CFR 47 rules, as administered by the Federal Communication Commission.
Digitrax believes any conscientiously installed equipment following guidelines
in this manual would be unlikely to experience RFI problems.
The DT402R is certified for “unlicensed” operations within the United States
by the US FCC and has the identifier as displayed on the unit case. Canadian
ID for DT402R is displayed on the unit case. See unit case for certification
identifiers from other countries.
Important Note: The DT402R is certified by the FCC and by Industry Canada
using a 12” LocoNet cable only. Any modification to the cable may void the
certification. For convenience an extension cord may be attached with a 6 pin
adapter for tethered use only.
For Canadian Users:
“This digital apparatus does not exceed the Class B limits for Radio noise
emission from digital apparatus set out in the Radio Interference Regulation or
the Canadian Department of Communications.”
Le present appariel numerique n emet pas de bruits radio-electriques depassant
les limites applicables aux appareils numeriques de la classe B prescrites dans
le Reglement sur le brouillage radioelectrique edicte par le ministere des
Communications du Canada.
FCC Information for RF24 module
FCC ID LV3RF24
IC 3015A-RF24