Desin Instruments HS-7000 Series, General Instructions Manual

Page: 79 / 108

79
●
Digital Output Operation Mode:
- For DO 1..3 in [ConF] [do 1..3] and in [P 04] modify the digit “n” in [???n].
- For DO 2..4 in [ConF] [do 2..4] and in [P 03] modify the digit “n” in [???n].
As Digital output [???0]
As Time Proportioning output [???1]
As Positioner output [???2]
●
Inversion of Digital Output:
- For DO 1..3 in [ConF] [do 1..3] and in [P 04] modify the digit “n” in [?n??].
- For DO 2..4 in [ConF] [do 2..4] and in [P 03] modify the digit “n” in [?n??].
For Direct output [???0]
For Inverted output [???1]
●
Minimum Correction Pulse:
- For DO 1..3 in [ConF] [do 1..3] and in [P 05] modify [nnnn].
- For DO 2..4 in [ConF] [do 2..4] and in [P 04] modify [nnnn].
Limits of Pulse value: 0 to 100%
●
Time Cycle:
When operating as Time proportioning, set the Time Cycle.
- For DO 1..3 in [ConF] [do 1..3] and in [P 06] modify [nnnn].
- For DO 2..4 in [ConF] [do 2..4] and in [P 05] modify [nnnn].
Limits of Time Cycle value: 0 to 9999 seconds
●
Positioner Time Course (only for Step by Step control):
Depends on the Positioner, set the time the valve lasts to open or close.
- Only for DO 1..3 in [ConF] [do 1..3] and in [P 06] modify [nnnn].
Limits Time Course value: 0 to 9999 seconds
●
Automatic Time Cousre calculation Command (only with Feedback signal):
Depends on the Positioner (Step by Step with Feedback), realize an automatic calculation of
the Time Course forcing the valve to go from 0 to 100%. The result is automaticallu introduced
in parameter
[P 06] [nnnn].
- For DO 1..3 in [ConF] [do 1..3] and in [P 08] modify [???n].
No operation [???0]
Calculate now [???1]
Note: When the calculation is finished, will return to [???0]