Delta CFP2000 Series, User Manual

Page: 82 / 756

Chapter 6 Control Terminals

CFP2000
6-7
6-2 Specifications of Control Terminal
Terminal
function
Group Conductor
Stripping
length [mm]
Max. wire
gauge
Min. wire
gauge
Torque ( ± 10%)
Relay
Ⓐ
Solid
4–5
1.5 mm 2
[16 AWG]
0.2 mm 2
[26 AWG]
5 kg-cm
[4.3 lb-in]
[0.49 Nm]
Strand
Control
board
Ⓑ
Solid
6–7
8 kg-cm
[6.9 lb-in]
[0.78 Nm]
Strand
Control
board
Ⓒ
Solid
2 kg-cm
[1.7 lb-in]
[0.20 Nm]
Strand
Wiring precautions:

In the figure above, the default for STO1, STO2, +24V and SCM1, SCM2, DCM are short circuit.
The +24V from section
Ⓒ
of above figure is for STO only, and cannot be used for other
purposes. The default for +24V-COM is short circuit and SINK mode (NPN); please refer to
Section 4 Wiring for more detail.

Tighten the wiring with slotted screwdriver:
Ⓐ Ⓑ
is 3.5 mm (wide) x 0.6 mm (thick);
Ⓒ
is 2.5 mm (wide) x 0.4 mm (thick)

When wiring bare wires, make sure they are perfectly arranged to go through the wiring holes.
Terminals Terminal Function Factory Setting (NPN mode)
+24V
Digital control signal common
(Source)
+24V  5% 200 mA
COM Digital control signal common (Sink) Common for multi-function input terminals
FWD Forward-Stop command
FWD-DCM:
ON

forward running
OFF

deceleration to stop
REV Reverse-Stop command
REV-DCM:
ON

reverse running
OFF

deceleration to stop
Figure 6-18
Table 6-1