Dell PowerEdge KVM 1081AD, User Manual

Page: 30 / 244

14
Installation
Figure 2-2. 2161DS-2/4161DS Remote Console Switch 1U Mounting Bracket Installation
To install the 2321DS Remote Console Switch mounting bracket:
1 Remove the three truss head screws from the right side of the switch
chassis, and position and attach the right mounting bracket to the right
side of the switch chassis with three of the flat head screws provided.
NOTE:
The switch vent holes must not be covered by the bracket, which will occur
if installed on the wrong side of the switch.
2
Repeat the procedure for the left side of the switch chassis.
3
Install a push nut to one end of the cable support rod. Position the
extensions with their slotted mounting flanges facing in opposing
directions.
4 Select a position hole on the lower side of the slide extensions. Slide the
support rod through the selected hole and the hole on the opposite
extension.
5 Install the remaining push nut on the other end of the cable support rod.
6 Slide the extension assembly into the switch chassis/bracket assembly as
shown in the illustration. Be sure to orient the extension assembly so that
the cable support rod is in the lower row of extension holes.