Dell PowerEdge 6350, Installation And Troubleshooting Manual

Page: 126 / 205

8-16 Dell PowerEdge 6350 Systems Installation and Troubleshooting Guide
1. If possible, enter the System Setup program and make a printed copy of the Sys-
tem Setup screens.
See Chapter 4, “Using the System Setup Program,” in the system User’s Guide for
instructions.
2. Turn off the system, including any attached peripherals, and disconnect the sys-
tem from its AC power source.
&$87,21 6HH ´3URWHFWLQJ $JDLQVW (OHFWURVWDWLF 'LVFKDUJHµ LQ WKH VDIHW\
LQVWUXFWLRQV DW WKH IURQW RI WKLV JXLGH
3. Open the panel doors on top of the computer.
See “Accessing the Interior of Your System” in Chapter 7.
4. If an expansion card blocks your access to the battery, remove the expansion
card.
See “Removing an Expansion Card” found earlier in this chapter.
5. Remove the battery.
Pry the battery out of its socket with your fingers or with a blunt, nonconductive
object such as a plastic screwdriver.
6. Install the new battery with the “+” side facing up (see Figure 8-11).
7. Reinstall the expansion card removed in step 4, if applicable.
8. Close the computer panel doors, reconnect the computer and peripherals to their
AC power sources, and turn on the system.
9. Enter the System Setup program to confirm that the battery is operating properly.
Enter the correct time and date through the System Setup program’s Time and
Date settings. Also reenter any system configuration information that is no longer
displayed on the System Setup screens, and then exit the System Setup
program.
)LJXUH ,QVWDOOLQJ WKH %DWWHU\
BATTERY socket
battery