Dell PowerEdge 6350, Installation And Troubleshooting Manual

Page: 91 / 205

Checking Inside the Computer 7-7
7URXEOHVKRRWLQJD:HW&RPSXWHU
Liquid spills, splashes, and excessive humidity can cause damage to the system. If an
external device (such as a printer or an external drive) gets wet, contact the device
manufacturer for instructions. If the computer gets wet, complete the following
steps:
1. Turn off the system, including any attached peripherals, and disconnect the sys-
tem from its AC power source.
&$87,21 6HH ´3URWHFWLQJ $JDLQVW (OHFWURVWDWLF 'LVFKDUJHµ LQ WKH VDIHW\ LQVWUXF
WLRQV DW WKH IURQW RI WKLV JXLGH
2. Open the panel doors on top of the computer.
See “Accessing the Interior of Your System” found earlier in this chapter.
3. Let the computer dry for at least 24 hours.
Make sure that it is thoroughly dry before proceeding.
4. Remove all expansion cards installed in the computer.
See “Removing an Expansion Card” in Chapter 8.
5. Close the computer panel doors, reconnect the system to the AC power source,
and turn on the system.
Does the system have power?
Yes. Go to step 6.
No.
See Chapter 12, “Getting Help,” for instructions on obtaining technical
assistance.
6. Turn off the system, disconnect it from the AC power source, open the panel doors
on top of the computer, and reinstall all expansion cards you removed in step 3.
See “Installing an Expansion Card” in Chapter 8.
7. Close the computer panel doors, and reconnect the system to the AC power
source.
8. Run the System Set Test Group in the Dell Diagnostics.
See Chapter 5, “Running the Dell Diagnostics.”
Do the tests complete successfully?
Yes. The system is operating properly.
No. See Chapter 12, “Getting Help,” for instructions on obtaining technical
assistance.