Dell PowerConnect J-8216, Hardware Manual

Page: 66 / 270

NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a J-EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Table 26: J-EX Series Switches Console Port Connector Pinout Information
Description Signal Pin
Request to send RTS Output 1
Data terminal ready DTR Output 2
Transmit data TxD Output 3
Signal ground Signal Ground 4
Signal ground Signal Ground 5
Receive data RxD Input 6
Data carrier detect CD Input 7
Clear to send CTS Input 8
Related
Documentation
See Routing Engine (RE) Module in a J-EX8216 Switch on page 26 for port location.
•
•
Connecting a J-EX Series Switch to a Management Console on page 136
Management Port Connector Pinout Information for a J-EX8200 Switch
The management port on a J-EX8200 switch uses an RJ-45 connector to connect to a
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T
connection. Two LEDs on the port indicate link/activity on the port and the administrative
status of the port. See “Management Port LEDs in J-EX8200 Switches” on page 29.
Table 27 on page 50 provides the pinout information of the RJ-45 connector. An RJ-45
cable, with a connector attached, is supplied with the switch.
Table 27: Management Port Connector Pinout Information for J-EX8200 Switches
Description Signal Pin
Transmit/receive data pair 1 TRP1+ 1
Transmit/receive data pair 1 TRP1- 2
50
Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide