Dell Latitude XT PP12S, User Manual

Page: 171 / 230

171
Installing the Palm Rest
1
Place the palm rest on top of the base, and engage the snaps around the
palm rest edges by pressing with your fingers in a counter-clockwise
manner.
2
Turn the Tablet-PC upside down and tighten the eleven M2.5 x 5-mm
bottom screws.
3
Turn the Tablet-PC top-side up and tighten the five M2.5 x 5-mm screws
labeled with a "P".
4
Connect the touch pad cable to the system board connector.
5
Install any mini cards (see "Installing a Mini Card" on page 156).
6
Install the keyboard (see "Installing the Keyboard" on page 160).
7
Install the display assembly (see "Installing the Display Assembly" on
page 165).
8
Install the hinge cover (see "Installing the Hinge Cover" on page 158).
9
Install the hard drive (see "Installing the Hard Drive" on page 146).
System Board
CAUTION:
Before performing the following procedures, follow the safety
instructions in your Product Information Guide .
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching a connector on the back panel of the
Tablet-PC.
NOTICE:
To avoid damaging the system board, you must remove the main battery
before you begin working inside the Tablet-PC.
Removing the System Board
1
Follow the procedures in "Before You Begin" on page 139.
2
Remove the hinge cover (see "Removing the Hinge Cover" on page 157).
1 palm rest 2 base
3 touch pad cable locking arm 4 touch pad cable