![background image](http://html1.mh-extra.com/html/daum-electronic/fitness-3/fitness-3_user-manual_514134034.webp)
32
Exchanging the Dashboard / Replacing the Battery
Required tools:
Phillips screwdriver / Blade 1 x 70 mm
Unplug the power cord!
(For your personal safety and to protect the sensitive electronic parts inside the dashboard)
1.
2.
The top part of the dashboard is secured to the bottom part by mean of 4 Phillips screws (A, B, C, D).
Use an appropriate screwdriver to unscrew these screws from underneath the dashboard. (See the
figure to the right) Please note that the screws C & D are located toward the outward border and are
deeply recessed in the dashboard bottom part. Do not unscrew the nearby located screws (X).
3.
Then you can remove the top part of the dashboard very carefully. First open the dashboard
housing by raising it from the higher side slightly and grasp (hold) with both hands underneath
the top shell of the dashboard. Raise the higher part of the dashboard top shell further until the
lower side separates from the dashboard support. Be careful to raise the top shell of the
dashboard housing only until you feel a slight resistance from the cables that are
connected from underneath, and until you can reach the connectors on the circuit
board with your thumb and index finger.
4.
You must unplug the connector.
Never pull on the cable to unplug it!! This would tear it off!
Never pull the cable!
It could tear off!
CAUTION!
Failure to correctly replace
the battery may create
an explosion risk.
Follow the same steps in reverse sequence to reassemble the dashboard top part.
5.
Plug the dashboard connector into the socket of the corresponding colour until it locks in position. Then pull carefully the cable
through the opening of the bottom part of the dashboard and the dashboard support and take care not to jam the cable when
you reinstall the top part of the dashboard on the bottom part.
6.
Screw the removed housing screws (A, B, C, D) from underneath the dashboard and tighten them.
7.
You can know plug the power cord, turn on the device and test its operation.
Replacing the dashboard battery
A button cell battery (CR 2032) is located on the underside of the dashboard circuit board. This battery must be replaced when
the time and date keeping function fails. Problems when turning on the machine and display failures are also signs of an empty
battery.
Warning: The device must be switched OFF when replacing the battery. Afterward you must
set the date and time.
Unscrew and remove the 4 screws on the dashboard holder. Then tilt the dashboard up carefully.
Take care not to separate any cable connection.
Never touch the electronic parts of the dashboard with your fingers! Charges of static electricity
can destroy the sensitive parts. Press the clip holder outward with a pin to replace the battery,
remove the battery and insert a new one with the plus symbol up. Reassemble the dashboard
carefully.
Caution! Do not squeeze any cable!
Notes about used button cell batteries
- Keep batteries away from children, and do not swallow them!
- Do not recharge empty batteries and do not throw them in fire.
Please recycle used batteries by bringing them to the appropriate collect point, or return them
to your dealer.
A
B
D
C
X
X
X
X
X
X
X
X
X
X
+
+
4.
Be careful when pulling the connector in order
to avoid damaging the circuit board and the
electronic parts!
+
Summary of Contents for Fitness 3
Page 1: ...3 3 3 User manual ...
Page 37: ......