![background image](http://html1.mh-extra.com/html/daum-electronic/fitness-3/fitness-3_user-manual_514134022.webp)
20
What to do, if ...?
?
In the case of a failure ................... what to do if...?
All our devices undergo a detailed test before they are shipped.
Should you, in spite of this, face a functional failure, the following recommendations should tell you what to do.
General procedure to identify the cause of a failure
The device consists essentially of two functional units
- the dashboard and the drive unit.
The dashboard contains the electronic circuits used for system control, display and data processing. The dashboard and
the drive unit communicate via a cable, which is routed through the handlebars column, having a connector on the
dashboard, on the drive unit and in the handlebars column.
Should the assembled device fail to function, the defect would generally be found either on the dashboard, the drive unit
or the cable connecting them.
The most frequent cause of complaints turns out to be jamming the connecting cable during
the assembly process of the device, or not properly plugging the cable connector.
In the event of a failure, check carefully first if
The cable connector located on the lower end of the handlebars column is properly connected, and that the cable was
not jammed or cut when the handlebars column was mounted onto the frame. To do this you need to disassemble the
handlebars column.
The cable was not jammed or cut while mounting the dashboard on the handlebars column, or if the cable connector
to the circuit board inside the dashboard is loose. To do this you need to disassemble the dashboard.
Fastening screws
Contacting your dealer or the service department of the manufacturer
We need the following information:
1.
(this number is on the silver label on the rear lower part of the frame).
The device serial number
3. The proof of purchase and the device reference sheet.
4. Ergometer bikes have a built-in failure diagnostic system, which signals device functionality using a red and a yellow
LED. These LEDs are located behind the transparent side cover (to the right side looking in the front direction) in the
upper right section on the circuit board of the drive unit, and can be seen from the outside (through the grid). With the
device switched on, the yellow LED should blink when pedalling slowly, and blink faster when pedalling fast.
With the device switched on, the red LED should light with high intensity when pedalling against a low load, and decrease
in intensity as the load increases.
Please inform us of the status of these LEDs for all complaints concerning "the device is not braking" or "the device is not
braking properly." This enables us to draw relatively concrete conclusions about the cause of the failure.
The drive unit is located inside the device, behind the saddle column. It contains the power supply, the eddy current brake
and the related electronic circuits.
All the fastening screws must be tightened from time to time. We recommend tightening them at least after the first
50 km and then once every 500 km.
2.
(you can access this number under the "Menu", "Information", "Version Data", "
Serial Number" on the graphic display)
The dashboard version number
If you wish to obtain more information on your device, please visit our service and repair hints web site on Internet
.
You can also call our service and repair hotline (telephone +49 / (0) 911 / 97 536-0).
(www.daum-electronic.de)
If the cause of the failure could not be identified, you should contact your dealer or the repair hotline of
daum electronic gmbh (telephone +49 / (0) 911 / 97 536-0).
Summary of Contents for Fitness 3
Page 1: ...3 3 3 User manual ...
Page 37: ......