![background image](http://html1.mh-extra.com/html/daum-electronic/fitness-3/fitness-3_user-manual_514134033.webp)
31
Simple Maintenance and Service Activities
Miscellaneous
Every 500 km of cumulated running distance you should check whether all the screws are still firmly set. Tighten them
back as needed. Care should be taken to remove sweat from the dashboard and the frame after every training session
to protect the paint against rust. Rust damage caused by sweat is not covered by the warranty. Use a soft cloth wetted
with water to clean the outer surface of the device. A light soap solution may also be used to wet the cloth.
Replacing the V-belt
Required tools:
Phillips screwdriver
6mm Allen wrench
1
1
1
Crank puller (commercially available)
Procedure to replace the V-belt:
Remove the protective cap (1) of the axle centre.
1.
Loosen the screw attaching the pedal rod (2).
(6mm Allen wrench).
2.
I Screw in an appropriate M 12 bolt, into the thread
of the pedal axle until the pedal comes off the axle shaft.
Hold the pedal firmly and remove it.
3.
Loosen the Phillips screws (3 to 5) on the lower right side cover.
4.
KA
1
2
3
4
5
Right side
The V-belt is located on the right side of the device
Unplug the power cable from the main power supply before opening the device!
The manufacturer will not be liable for any damages arising as a result
of negligence while changing the V-belt!
V-belts are wearable parts and as such are not covered by the warranty.
Take particular care to avoid damaging the internal parts of your ergo_bike while you are working.
Carefully remove the side cover.
5.
6.
The driving parts on the carrier plate /drive unit are now freely
accessible. Press on the belt tension lever against the tension
spring (9h) to release the V-belt tension, and then pull the belt
from the pulley (9a).
Follow the same steps (1 to 6) as described above
in reverse sequence to install the new V-belt.
Before installing the new V-belt, you should clean the belt slipping surfaces of the pulley and the drive shaft,
as well as the belt itself, with alcohol or cleaning petrol to remove the grease.
9a
9r
9p
Spring
9h
Tension
lever
9g
9c
Summary of Contents for Fitness 3
Page 1: ...3 3 3 User manual ...
Page 37: ......