Datavideo HS-3200, Instruction Manual

Page: 148 / 168

148
1.
Open the CG settings page.
2.
Enable the CG function.
3.
In the Text field, enter the overlay text.
4.
Enter the X and Y coordinates to set the text position.
5.
Click the Apply button to save the new settings.
Note: Increasing the X coordinate moves the overlay text to the right and decreasing the X
coordinate moves the overlay text to the left; increasing the Y coordinate moves the
overlay text up and decreasing the Y coordinate moves the overlay text down.
7.4 Stream and Record Buttons
The RECORD and STREAM buttons on the front panel of the HS-
1300 give the user certain controls of the record and stream
functions. In this section, we will cover operations of these two
buttons in detail.
Button LED behaviors and their corresponding states are listed in
the table below:
RECORD Button STREAM Button STREAM Button
Solid White
Record function in
idle state Stream function in
idle state Record/Stream functions in
idle state simultaneously
Blinking Red
Record function is
activating or
resetting Stream function is
activating or
resetting Record/Stream functions
are activating or resetting
simultaneously
Solid Red
Record function
activated Stream function
activated Record/Stream functions
are activated simultaneously
Record Button
Start recording

When idle, the RECORD button is solid white.

Press and hold the RECORD button for approximately 2 seconds.

When the record function is activating, the RECORD button turns from solid white,
then blinking red and finally to solid red.

When the RECORD button is solid red, this indicates that the record function has
been successfully activated.
Note: The RECORD button is disabled in the Stream Only mode.
Stop recording

While recording, the RECORD button is solid red.

Press and hold the RECORD button for approximately 2 seconds.