Datavideo HS-3200, Instruction Manual

Page: 110 / 168

110
Before using this feature, the four keyers must be set to PIP mode and the four FLEX
windows must be adjusted and positioned accordingly. The steps outlined below will guide
you in configuring the eight PIP windows.
1. Enable Flex™ output on PGM or PVW window (press SHIFT and while holding down the
SHIFT button, press the FLEX button). This will display the Flex™ output layout on either the
PVW or PGM screen so that you will be able to configure the Flex™ output windows while
viewing the changes.
2. Pre-configure the four Flex™ output windows in the P-in-P sub menu by adjusting the size
and position of the corresponding windows. Remember to modify the luma key parameters
accordingly. Note that you can change the
Flex™ output window content in the Flex Src sub
menu.
P-in-P Keyer Flex PinP 1 Fine Normal
Position X 20% Y 10% Size 40%
Border Normal
Luma 100% Sat 80% Hue 0
Width 2% Soft 0% Opac 100%
Shade Matte Luma 100% Sat 80% Hue 60
Shade Soft 2% Shade Pos 50 Direction 35
Crop Left 0% Right 0% Size 0%
Top 0% Bot 0% Soft 0%
3. Open the Keyer sub menu, set Keyers 1 – 4 to PIP mode and enable Luma Key .
Keyer Keyer Key 1
Keyer Ctrl Luma P-in-P Opac 100%
Lift 0% Gain 1.0 Invert Off
Key Source Input 1 Fill Black
Mask Left 0% Right 0%
Top 0% Bot 0%
4. Adjust the P-in-P windows in the P-in-P sub menu.
P-in-P Keyer Key 1 Fine Normal
Position X 20% Y 10% Size 40%
Border Normal
Luma 100% Sat 80% Hue 0
Width 2% Soft 0% Opac 100%
Shade Matte Luma 100% Sat 80% Hue 60
Shade Soft 2% Shade Pos 50 Direction 35
Crop Left 0% Right 0% Size 0%
Top 0% Bot 0% Soft 0%