Datalogic QuickScan Lite QW2400, Product Reference Manual

Page: 31 / 288

RS-232 ONLY Interface Enter/Exit Programming Mode
Product Reference Guide 23
Stop Bits
The stop bit(s) at the end of each transmitted character marks the end of trans-
mission of one character and prepares the receiving device for the next charac-
ter in the serial data stream. The number of stop bits selected (one or two)
depends on the number the receiving terminal is programmed to accommo-
date. Set the number of stop bits to match host device requirements.
Parity
This feature specifies parity required for sending and receiving data. A parity
check bit is the most significant bit of each ASCII coded character. Select the
parity type according to host device requirements.
• Select None when no parity bit is required.
• Select Odd parity and the parity bit value is set to 0 or 1, based on data, to
ensure that an odd number of 1 bits are contained in the coded character.
• Select Even parity and the parity bit value is set to 0 or 1, based on data, to
ensure that an even number of 1 bits are contained in the coded character.
$CR2ST00 
1 Stop Bit
$CR2ST01 
2 Stop Bits
DEFAULT
$CR2PA00 
Parity = None
$CR2PA01 
Parity = Even
$CR2PA02 
Parity = Odd
DEFAULT