Datalogic QuickScan Lite QW2400, Product Reference Manual

Page: 24 / 288

Setup
16 QuickScan™ Lite QW2400
Resetting the Product Configuration to Defaults
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the Custom Default Configuration
that may have been saved in the scanner, scan the Restore Custom Default Config-
uration bar code below. This will restore the custom configuration for the cur-
rently active interface.
If you aren't sure what programming options are in your scanner, or you've
changed some options and want to restore the Factory Configuration, you have
two options. You can scan the Restore USA Factory Configuration bar code or the
Restore EU Factory Configuration bar code below. Both labels restore the scanner
configuration to the factory settings including the interface type. The USA label
restores Label IDs to those historically used in the USA. The EU label restores
Label IDs to those historically used in Europe. The Label ID sets for USA and EU
are shown in the Label ID section of this manual.
The programming section on the following pages lists the factory default set-
tings for each of the menu commands (indicated by shaded blocks and bold
text).
NOTE
Custom defaults are based on the interface type. Configure the scanner for
the correct interface before scanning this label.
CAUTION
Scanning either of the “Restore Factory Configuration” commands below
will result in the loss of any custom configuration settings for your device.
$P,HA00,P
Restore Custom Default Configuration
Restore USA Factory Configuration
$P,AE,P
Restore EU Factory Configuration
$P,Ae,P