30
SR200 & SR300 Printer User Guide
Printer Setting tab
The Printer Setting tab shows:
•
Controls for viewing or changing print settings:
— YMC Ink Print Level, which sets the print
density for color printing.
Choose from
seven gradations from -3 (lighter) to +3
(darker).
— Resin K Ink Print Level, which sets the K
resin ink print density.
Choose from seven
gradations from -3 (lighter) to +3 (darker).
— UV Ink Print Level.
Choose from seven
gradations from -3 (lighter) to +3 (darker).
— Peel Off Ink Print Level.
Choose from seven
gradations from -3 (lighter) to +3 (darker).
— Resin K Ink Print Mode which sets the K resin ink print quality. If Fine is
selected, the print quality improves but the printing speed is slower.
Change
to Fine if thin lines or small black text is blurred (printing speed is slower).
— MG Peel Mode which sets the printer to use peel off ribbon in the magnetic
stripe area (if installed).
— Standby Mode which pauses the card after printing and before transferring
the card to the laminator.
— Back Side Cooling which pauses the card to cool it when printing on both sides
of the card.
•
Controls for viewing or changing magnetic stripe settings.
— Number of Retry, which sets the maximum number of retries when writing or
reading magnetic stripe data fails. Default value is 1.
— ISO Mode, which sets the power used by the magnetic card encoder. The
default is Hi-Co.
•
A control to enable or disable the buzzer.
•
A control to set the display contrast.
•
A control to set the display mode.
•
A control to change the display counter.
•
Controls to set power saving, which reduces the temperature of the retransfer heat
roller after the printer is not used for the chosen time. The roller returns to operating
temperature when the next card is printed.
— The interval to wait until power saving takes effect.
Choose from OFF for network
operation or select from 5 to 60 minutes in 5 to15 minute increments (for a USB
connection).
The default is OFF
— Setting HR Control to Enable can add to the useful life of the retransfer heat
roller. The default is Enable.
— “Sleeping” appears on the LCD display. To cancel power save mode, press
Reset and then the Enter key. The printer uses one set of supplies.
•
The Update button updates the printer settings.
•
The Refresh button displays the printer settings.
