24
SR200 & SR300 Printer User Guide
Printing Area Settings
On the Print tab, click “Enable the Print Area” and
click the “Settings” button to define nonprinting
areas of a card design. Also use with peel-off
(YMCK-PO) ribbon.
You can block YMCK printing areas, but
the protective layer from the retransfer
material will be applied to the card. The
Print Area window contains settings for x
and y starting coordinates, height and
width of print area, ink type, card side, and
energy settings.
To define a non-printing area:
1
Enter the x and y coordinates of the
start position and the height and width in millimeters.
2
Select “1. Peeloff” (or 2. YMCK) from the Ink list.
3
Choose “1. Front” or “2. Back” from the Side list.
For ISO magnetic stripe, use the following values:
4
The Peel-off Ink Energy settings affect the print
density or strength of peel-off. For best results,
use the default settings. The driver sets the width
of each area.
5
Click the Add button to add the Print area. You can
add up to eight print areas, but only one area per
side, beginning at the 0,0 position, is supported.
Printer Settings
On the Print tab, the “Enable printer settings” feature is available if run as an Administrator.
See the
“Configuration tab” on page 25
for more information about this setting. Click
“Settings...” to open the Settings dialog box. The Settings dialog provides a convenient
location to manage settings provided on several tabs in the Status Monitor. See the
“Printer
Setting tab” on page 30
, the
“Retransfer tab” on page 31
, or the
“Bend Remedy tab” on
page 31
for more information about settings available.
X start
Y start
Width
Height
Ink
Side
0
0
87.46
17.86
1 Peeloff
1. Front
0
0
87.46
21.42
2 YMCK
1. Front
