DANA SPICER Axle 123, Service Manual

Page: 54 / 236

54
ASSEMBLY
Dana Holding Corporation ASM-0007E - 123 Axle Service Manual
FIGURE 18: Using special tool T3 (See drawing T3 p. 59),
partially insert the thrust block of the bearings (3) (6) and
shims (4) .
FIGURE 19: Connect the tension rod to the press and move
the thrust block of bearings (3) (6) into the seats.
Disconnect the press and remove the tension rod.
NOTE:
Before starting the next stage, make sure that the thrust
block has been completely inserted into its seat.
T3
3
4
6
FIGURE 20: CALCULATING PINION BEARINGS ROLLING
TORQUE
Introduce tool T4 (See drawing T4 p. 60) complete with bea-
rings (3) and (6) into the main body (12); tighten by hand until
a rolling torque is definitely obtained.
FIGURE 21: Introduce the tracer of a depth gauge “DDG” into
either side hole of tool T4 (See drawing T4 p. 60). Reset the
gauge with a preload of about 3 mm.
FIGURE 22: Remove the comparator and take out tool and
bearing cone kits from the main body.
T4
3
6
12
DDG DDG
A
A
T4 T4
6
3
Property of American Airlines