DANA SPICER Axle 123, Service Manual

Page: 109 / 236

ASSEMBLY
21 Dana Holding Corporation ASM-0029E - 223 Axle Service Manual
FIGURE 26: Fit the flange (14) in the ring gear (13) and lock
into position with snap ring (12).
NOTE:
Check that snap ring (12) is fully inserted in the slot of ring
gear (13).
FIGURE 27: Mount gears (10) onto the pins of the planetary
cover (2).
To insert gears, use tool T6 (See drawing T6 p. 28).
The radiused part of bearings' inner ring must face the bot-
tom of the pin.
13
14
12
T6
2
10
9
2
10
CAUTION
FIGURE 28: Lock gears (10) into position by installing the
snap rings (9).
FIGURE 29: Oil the seal ring and bushing. Slip the steering
case (3) onto the twin u-joint and fit the pivot pins and con-
nect the steering bar.
For details, see PLANETARY REDUCTION GEAR p. 15.
FIGURE 30: Only if studs have been removed. Apply a coat
of Loctite 270 to the fast end of studs (19) and apply Tecno-
lube 101 to ground nut end; tighten studs (19) as far as they
will go.
9
10
3
Loctite 270
Tecnolube 101
Property of American Airlines