DANA SPICER Axle 123, Service Manual

Page: 128 / 236

40
ASSEMBLY
Dana Holding Corporation ASM-0029E - 223 Axle Service Manual
FIGURE 30: Sensor wiring diagram for STANDARD version.
FIGURE 31: Sensor wiring diagram for OPTIONAL version.
FIGURE 32: Center by slowly moving the piston first in one
direction, then in the opposite one, position the piston in the
middle point of the stroke, which is determined by the control
device signalling lamp turning on and switching off in the re-
verse stage.
1
2
3
4
--
+
I max=0,80 A
NERO
BLACK
BLUE
MARRONE
BROWN
2 A
CONNECTOR
BATTERIA
BATTERY
CONNETTORE
BLU
1
2
3
4
--
+
I max=0,80 A
NERO
BLACK
BLU
BLUE
MARRONE
BROWN
2 A
CONNETOR
CONNECTOR
BATTERIA
BATTERY
=
=
=
=
=
=
FIGURE 33: Check distance "C" of piston on either of the two
sides and write down distance dimension to check subse-
quent adjustments.
NOTE:
For cylinders without sensors, piston must be centered
based on maximum stroke.
FIGURE 34: Lay level "L" on two upper studs and line them
up. Apply tools T2 (See drawing T2 p. 43) to the two horizon-
tal studs; hold them in position with two nuts, level them, and
finally lock into position.
FIGURE 35: Without moving the piston, check front and rear
stud between the edges of tools T2 (See drawing T2 p. 43)
maximum allowed difference: 1 - 1.5 mm.
CC
L
L
L
L
T2
T2
T2
T2
T2
Property of American Airlines