DANA SPICER Axle 123, Service Manual

Page: 171 / 236

ASSEMBLY
83 Dana Holding Corporation ASM-0029E - 223 Axle Service Manual
FIGURE 24: Deviation “H” must be added to a set value of
0.12--0.13 mm (X) to obtain calibrated spacer “S1” (7) for in-
sertion between inner bearing (6) and spacer (8).
Dimension “S1” must be rounded off to the higher 5/100.
EXAMPLE: S1 = H + X = 1,8 + (0.12 - 0.13) = 1,92 - 1,93 mm.
FIGURE 25: Heat the inner bearing (6) to about 212 °F [100
°C] and fit it onto the pinion (5).
NOTE:
Once the bearing has cooled down, lightly lubricate bea-
ring (6) with SAE85W90 oil.
FIGURE 26: Make sure that the bearing (6) is well set.
7 S1
100°
6
5
6
FIGURE 27: Refer and keep to the positions marked during
disassembly.
FIGURE 28: Fit the pinion (5), calibrated spacer “S1” (7) and
spacer (8) in the main body (12).
FIGURE 29: Heat the external bearing (3) to a temperature of
about 212 °F [100 °C] and fit it on to the pinion (5) to complete
the pack as shown in the figure above.
NOTE:
Lightly lubricate bearing (3) with SAE85W90 oil.
7
17
8
5
3
5
Property of American Airlines