Control Options Setup
25
RSSI Values
RSSI Values
Signal Strength
-40dBm to -60dBm
Signal Good
-61dBm to -75dBm
Signal Fair
<-76dBm
Signal Poor – Check antennas, antenna cables, locations, height off
ground, obstacles, etc.
Verify Connections
1�
Verify that the number of connected clients shown on the LCD is correct.
2�
Verify the Quality of service eventually goes to 100 (this may take a minute or two)
and stays there.
3�
If either of the above verifications fail, check the installation and configuration.
•
The Quality of Service section of the server configuration page can be used to
determine which client is having trouble.
• The RSSI value can be used to determine if the problem is with radio signal
strength. This is an average value of strength from all clients. Enable 1 client at a
time to get an RSSI reading for an individual client.
Auto Reset Feature
•
Radios with firmware version 2187 and higher have an auto reset feature.
•
The server radio resets every 30 seconds if it does not find any client radios with which
to connect.
•
A client radio resets every 30 seconds if it does not find a server radio with which to
connect.
• The auto reset feature is disabled when there is a connection on the Ethernet port
(when connected with a computer).
•
On initial setup, it may take a few reset cycles for all the radios to find each other,
and the Quality of Service number may take a few minutes to reach 100 percent.
Handheld Controller Insert and Code
The handheld controller uses a keypad insert to program
price information for Daktronics LED Fuelight
™
Displays.
The controller’s insert, illustrated in
, is used to
control the displays.
If an insert is lost or damaged, make a copy from
DWG-167856
located in
. Cut the insert to size and slide it into
the controller’s pocket to use as a reference until a
replacement is received.
To start the controller and use the insert to program
information into the display driver, follow the instructions in
the control quick guide provided with the control kit.
0
1
2
3
4
5
6
7
8
9
UPDATE
DISPLAY
DIMMING
MENU
ENTER
*
EDIT
CLEAR
SET FUNCTION
LL-2551
DM-100
Figure 58:
Handheld Controller
Insert
