Control Options Setup
17
Client Radio Installation
1�
Turn off power to the display
during the installation of the
radio.
2�
Mount the client radio at or
within 25' (7.6 m) of the display.
3�
Connect signal cables as
follows. The letter for each step
is noted in
a�
Attach the 8' (2.4 m)
provided cable to the host
driver at J16.
b�
Attach the mating jack
end to the display cabinet.
The cable may be routed
through a conduit knockout in the display to the side of the structure or shrouding.
Use cable bushings to protect the cable from rough edges.
c�
Connect the quick-connect cable from the client radio to the mating jack at the
display. The quick-connect cable is pre-terminated in the client radio.
4�
Secure loose cable to protect it from weather or vandalism.
Outdoor J-box Installation
1�
Choose a location and attach the J-box,
shown in
pole so it is easily accessible for plugging in
the handheld controller. Mounting tabs may
be attached to the back of the J-box with
provided screws.
2�
Orient the box so the quick-connect cable
runs out the bottom of the box.
3�
Connect the unterminated end of the quick-
connect cable inside the outdoor J-box
according to the table below.
Outdoor J-box Terminal
Wire Color
TB3-1
Red
TB3-2
Green
TB3-3
White
TB3-4
Black
4�
Connect the 8' (2.4 m) provided cable to J16 on a display driver.
5�
Route the cable through a knockout in the display and mount to the side of the sign
structure. Use cable bushings to protect cable from rough edges.
6�
Connect the quick-connect cable from the J-box to the bulkhead connector on the
side of the sign structure.
Inside
Display
Cabinet
Cable
to
Driver
Quick-Connect
Cable From
Client Radio
C.
B.
A.
Client Radio
POWER
IN
24 DC
J14
DIGIT 4
J13
DIGIT 3
J12
DIGIT 2
J15
DECIMAL
J11
DIGIT 1
J18
J10
J9
J16
Figure 34:
Client Radio Connections
Figure 35:
Outdoor J-box
