Control Options Setup
14
9�
Connect the receiver cable from receiver to the driver. Refer to
.
Figure 30:
Final Receiver Assembly
Digit Cabinet
Driver
Receiver
Antenna Cable
10�
Neatly secure any excess cable with cable ties.
11�
Close and secure the digit face.
Set Security DIP Switches
The FLR3-100 key fob has a series of DIP switches on the back to give it a unique address
setting. Set these switches to a unique setting to prevent unauthorized control of the
display.
1�
Remove the small cover on the
back of the FLR3-100 key fob.
.
2�
Using a paper clip or a micro
screwdriver, set the switches to
a unique setting.
Note:
Do not change
switches 9 and 0.
3�
Replace the back cover.
Pair Key Fob with Display
To pair the FLR3-100/400 key fob with the radio receiver in the display, follow these steps:
Note:
If these steps are not completed, the display will not recognize or respond to the
key fob.
1�
Turn power on to the display.
2�
While display is booting up, or within five minutes, press and hold the
LINE 1
plus (+)
and minus (–) buttons until the decimal flashes three times. The display should now be
paired with the key fob.
Boot Sequence
When the display is powered up, you will see a boot sequence. The table defines the
information shown on the display and its meaning.
Information Shown
Meaning of Information
FLx
x = 3, 3000 Series Fuelight Display (3rd digit control, U.S.)
x = 4, 4500 Series Fuelight Display (4th digit control, International)
Rxx
xx = Revision
LL-2855 REV00
CONFIG
ADDR
SYNC
4
3
2
LINE
1
TEST
1 2 3 4 5 6 7 8 9 0
ON
1 2 3 4 5 6 7 8 9 0
ON
Figure 31:
FLR3 Key Fob DIP Switches
