Cash/Credit Display Installation
11
Display Identification
Identify 2H x 2W cash/credit
modules by their position when
viewed from the front. Refer to
.
shows the identification
used for an alternate size 1H x 2W
display.
Install the Display
A rectangular opening must
be provided to accommodate
the Cash/Credit display. Refer
to the
Shop Drawing
for cutout
dimensions.
1�
Remove existing displays.
2�
Provide a rectangular opening in the sign structure to
accommodate the Cash Credit display. Refer to the
Shop Drawing
for cutout dimensions.
3�
Lift displays into the sign structure.
shows a
display being inserted into a sign structure.
4�
Drill through the front flanges of the cabinet to attach
the display to the base structure using appropriate
hardware for site conditions. Refer to
Actual site demands will dictate variances and
appropriate mounting methods.
Figure 23:
Secure Display in Sign Structure
5�
Repair and seal any unused openings in the sign structure.
Note:
Openings greater than 1/2" (12.7 mm) in diameter require a metal patch
secured by screws or rivets and caulked with non-hardening caulk. Smaller
openings may be sealed with non-hardening caulk.
Access Internal Components
The door of Cash/Credit displays is secured by a screw (two screws secure the door on
2H displays).
1�
Use a Phillips-head screwdriver to loosen the screw.
2�
Open the door using the knob attached to the display face.
3�
The power supply is attached inside the cabinet to the display’s backsheet, as shown
, and its location varies between display sizes.
Top Left
Top Right
Bottom Right
Bottom Left
Figure 20:
2H2W Display Identification
Left
Right
Figure 21:
1H2W Display Identification
CORNER GAS
REG
DSL
UNL
Figure 22:
Inserting Display Into
Cabinet
