FLR3-1500 and FLD3-2000 Handheld Controller
31
8 FLR3-1500 and FLD3-2000 Handheld Controller
After completing power and signal installation, set up the handheld controller.
Set Gas Price Function
To operate petroleum price displays, the handheld controller must first be programmed
to the GAS PRICE function. Use the
SET FUNCTION
key on startup. The following tables list
start-up procedures for both gas price and rate (used for international displays).
Note:
Perform these steps only the first time the controller is powered up.
LCD Screen
Action/Information Shown
CURRENT FUNCTION
GAS PRICE
For indoor installation only:
Plug the wall pack transformer into a
120 VAC power outlet, and connect it to the DM-100.
This display appears briefly.
CHANGE FUNCTION?
PRESS SET FUNCT
If GAS PRICE is shown on the bottom line of the LCD during startup,
do nothing. The controller automatically defaults to previous gas
price settings.
If a function other than GAS PRICE is shown on the bottom line
of the LCD during startup, press the
SET FUNCTION
key while the
second LCD prompt is displayed.
SELECT FUNCTION
GAS PRICE }{
Press the
Up
and
Down Arrow
keys until the GAS PRICE option is
shown, and then press
ENTER
to accept.
FL-4500 Rate Display Setup
Set international displays to the rate display function, which should position the decimal
point in the correct position. Instructions are provided below if the decimal point is not
automatically repositioned.
LED Screen
Action/Information Shown
CHANGE FUNCTION?
PRESS SET FUNCT
When this message appears on the screen, press
SET FUNCTION
.
SELECT FUNCTION
RATE DISPLAY }{
Press the
Up
and
Down Arrow
keys until the RATE DISPLAY option is
shown. Press
ENTER
to accept.
DISPLAY MENU
ENT TO BEGIN
Press the
MENU
key, press the
Up
or
Down Arrow
keys to select
DISPLAY MENU, and then press
ENTER
.
DISPLAY OPTION
ENT TO EDIT
Press the
Up
or
Down Arrow
keys to select DISPLAY OPTION, and
then press
ENTER
.
DISPLAY OPTION
$00.00 }
Press the
Down Arrow
key to move the decimal point, and then
press
ENTER
when the decimal point is positioned correctly.
DISPLAY $000.0
ENTER TO UPDATE
Press
ENTER
again to accept the decimal point location change.
