Arize
®
Life
2
Installation Guide
5
METHOD 2
Directly Interconnected Luminaires
Before starting:
See Multiple Bar Installation Details to ensure you won't exceed the maximum run length per leader cable.
Luminaires must only be mounted using Current’s standard or slim mounting clips (see Components Required on page 3).
Linear Layout
Parallel Layout
Press the luminaire into its mounting clips so that
the male connector is oriented towards the intended
electrical supply. TIP: Align luminaire on one side of the
mounting clips, then rotate the luminaire until it snaps
into other side of the mounting clips.
Secure each luminaire mounting clip to a rigid flat
mounting surface using two #10 (M5) self-tapping
flathead screws along the intended run of luminaire.
To avoid stress and damage to luminaire the entire
mounting surface should be flat and the mounting
clips properly aligned. Refer to table on page 8 for
the required number of mounting clips per luminaire.
Align using chalk line, laser projector or similar
1
2
NOTE:
the recommended distance between two ends should be no more than 0.8" (20mm) for better optical uniformity.
NOTE:
the recommended maximum space between parallel luminaires is 10" (245mm) for better optical uniformity.
Align using chalk line, laser projector or similar
Male connector towards electrical supply
Rotate and Push
SNAP!
SNAP!
SNAP!
SNAP!
SNAP!
SNAP!
1A
2A
SNAP!
SNAP!
SNAP!
SNAP!
SNAP!
SNAP!
SNAP!
SNAP!
Male connector towards electrical supply
End cap