SiEBE18-526
Instruction
System Configuration
197
FTXS20/25/35C
.
Care and Cleaning
CAUTION
Before cleaning, be sure to stop the operation and
turn the breaker OFF.
Units
Indoor unit, Outdoor unit and Remote control
Front grille
1. Wipe them with dry soft cloth.
1. Open the front grille.
•
Hold the grille by the tabs on the two sides and lift it
unitl it stops with a click.
2. Remove the front grille.
•
Supporting the front grille with one hand, release
the lock by sliding down the knob with the other
hand.
•
To remove the front grille, pull it toward yourself
with both hands.
3. Clean the front grille
•
Wipe it with a soft cloth soaked in water.
•
Only neutral detergent may be used.
•
In case of washing the grille with water, dry it
withcloth, dry it up in the shade after washing.
4. Attach the front grille
•
Set the 3 keys of the front grille into the slots
and push them in all the way.
•
Close the front grille slowly and push the grille
at the 3 points.
(1
on
each sides and 1 in the middle.)
•
Check to see if the rotating axis in the upper
center section is moving.
Fit the key
into the slot.
CAUTION
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an injury.
• When removing or attaching the front grille, use a robust and stable stool and watch your steps carefully.
• When removing or attaching the front grille, support the grille securely with hand to prevent it from falling.
• For cleaning, do not use hot water above 40
°
C, benzine, gasoline, thinner, nor other volatile oils,
polishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front grille is securely fixed.
Summary of Contents for Super Multi Plus D-Series
Page 1: ...SiEBE18 526 D Series Service Manual Applied Models zSuper Multi Plus Heat Pump...
Page 12: ...SiEBE18 526 List of Functions 1 Part 1 List of Functions 1 List of Functions 2...
Page 63: ...Refrigerant Flow for Each Operation Mode SiEBE18 526 52 Refrigerant Circuit...
Page 249: ...Instruction SiEBE18 526 238 System Configuration...