WEB Operations
27
Figure 3-17 Eagle-Eye Map
Adjust the size of the rectangle in the eagle map by mouse or by using the scroll wheel to
change the display range of the main window. Drag the rectangle in the eagle map you can
change the area that is displayed in the main window.
3.3.9 Screen Management
You can control the open and close of screens, set back light mode for screens, modify
parameters of screens, select input signals for screens, and set signal modes for the screens.
3.3.9.1 Opening and Closing Screens
After you have connected the Controller to serial ports on the screen, you can open and close
screens.
You have to connect screens to RJ-45 serial ports on the motherboard, and then you can
control the open and close of the screen. Wiring instructions are as follows.
Port 1 is RXD, Port 8 is TXD, and Port 5 is GND.
Instructions of other lines:
On the Liquid Crystal Display, Port 2 is for receiving data, Port 3 is for sending data, and
Port 5 is connected to the ground wire.
In the RJ-45 serial port of the motherboard, Port 1 is for receiving data, Port 5 is connected
to the ground wire, and Port 8 is for sending data. See Figure 3-188.
