Daedong EX50-SA, Manual

Page: 102 / 196

5
-
10
EX50-SA / EX55-SA / EX5310-AU / EX5810-AU
JUMP STARTING
(1) Dead Battery (2) Jumper Cables
(3) Helper Battery
If the battery is discharged and the
engine cannot be started, it is possi-
ble to start the engine by connecting
the discharged battery to a battery
from another tractor or other extra
battery.
1. Check that the voltage of the dis-
charged battery is same as the volt-
age of the other tractor or vehicle
for jump start. (Specification for this
tractor: 12 V)
2. Check the length of the jump cable
and position another tractor near
the tractor with the discharged bat-
tery. Then, put all the shift levers in
the neutral position, apply the park-
ing brake, and stop the engine.
3. Wear protective glasses and gloves
and open the hoods of both trac-
tors. Remove the battery terminal
cover as necessary.
4. Connect the alligator clips on both
ends of the red positive cable to the
positive terminals of both batteries.
5. Connect one clip of the black nega-
tive cable to the negative terminal
of the normal battery and the other
clip to the tractor body with the
discharged battery. Make sure to
connect the clip to the body part
without paint.
6. Start the engine of the tractor
with the normal battery.
7. Start the engine of the tractor
with the discharged battery.
8. Disconnect the black cable from
the negative battery terminals of
both of the tractors.
9. Disconnect the red cable.
10. Run the engine for at least 30
minutes to charge the discharged
battery.
11. If the battery is discharged again,
replace it or check the charging
system, such as the alternator.
T46O511A
TE150 (EX50, EX55)-���-05.indd 10 2019-03-19 �� 7:03:15